15075 Autoloader ALE: trailing edge clamps failed to lock All Check the clamp lock sensor see is it is operational. Use "tec" command from the diagnostics to display the sensor status. If the sensor is faulty, use "set al tls 0" to bypass the sensor and get the customer going. Arrange for field service. If the sensor is OK, test the TEC lock/unlock mechanism by using "tec lock" or "tec unlock" and see if any motion occurs. Click RESUME to see if the error goes away. If not, call Creo for service. Faulty clamp unlock sensor Faulty TEC lock/unlock mechanism. ../nvs/al_cal_tls.xmlNVS: al tls ../commands/tec.xmlCommand: tec ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:51 2008 PST